Blog

Answers about Electronics Engineering

The type of diode that exhibits negative resistance is called a tunnel diode or Esaki diode. It is a semiconductor diode that has a very narrow depletion region

Read more

Electronics Engineering

What is the advantages of using the bridge rectifier over the center tapped rectifier?

Asked by Wiki User

Bridge rectifiers offer several advantages over center-tapped rectifiers: Higher Output Voltage: Bridge rectifiers can produce nearly double the output voltag

Read more

Electronics Engineering

+1

What is difference between Rectangular Waveguide and Circular Waveguide?

Asked by Wiki User

Rectangular waveguide and circular waveguide are metal hollow structure used to guide EM waves. Depending upon their shapes they are classified as rectangular o

Read more

Electronics Engineering

Which vacuum based device is widely used as a power amplifier in satellite communication system?

Asked by Wiki User

The Traveling Wave Tube Amplifier (TWTA) is widely used as a power amplifier in satellite communication systems. It amplifies signals in the microwave frequency

Read more

Electronics Engineering

What is the output impedance of common source amplifier circuit?

Asked by Wiki User

The output impedance of a common source amplifier circuit is typically high. This is because the common source amplifier uses a resistor to provide biasing, whi

Read more

Electronics Engineering

What is unidirectional current controller?

Asked by Wiki User

A unidirectional current controller device is a type of electrical on/off switch. In order for an item to work that is plugged into a particular outlet, the swi

Read more

Electronics Engineering

What is the lowest frequency that can be generated using mode 1 if the crystal frequency is 11.0592 MHz Show your calculations?

Asked by Wiki User

To calculate the lowest frequency that can be generated using mode 1, we need to divide the crystal frequency by two. So, the lowest frequency that can be gener

Read more

Electronics Engineering

When is the resistor bypass used in the ignition circuit?

Asked by Wiki User

The resistor bypass in the ignition circuit is used when starting the engine. It bypasses the resistor to provide full battery voltage to the ignition coil, ens

Read more

Electronics Engineering

Can a 200 kHz unit work on a 192 kHz transducer?

Asked by Wiki User

No, a 200 kHz unit will not work on a 192 kHz transducer. The frequency of the unit and the transducer need to match in order for them to work together effectiv

Read more

Electronics Engineering

What is the 555 IC timer measured in?

Asked by Wiki User

The 555 IC timer is typically measured in units of time, such as microseconds (µs), milliseconds (ms), or seconds (s). It can be used bitcoin Price to Invest generate precise timing

Read more

Electronics Engineering

Why random signals are called power signals?

Asked by Wiki User

Random signals are called power signals because they have finite power, meaning they have a non-zero average power over time. Power signals are characterized by

Read more

Electronics Engineering

What is the full form of ITU in standards?

Asked by Wiki User

The full form of ITU in standards is the International Telecommunication Union. It is a specialized agency of the United Nations that focuses on developing inte

Read more

Electronics Engineering

For a parallel plate capacitor is The poynting vector points everywhere radially outward of the volume between plates?

Asked by Jahnavi252

No, the Poynting vector does not point radially outward in the volume between the plates of a parallel plate capacitor. The Poynting vector represents the direc

Read more

Electronics Engineering

When tri state logic device is in the 3rd state then?

Asked by Wiki User

When a tri-state logic device is in the third or high-impedance state, it means that it is effectively disconnected from the circuit. This state allows multiple

Read more

Electronics Engineering

How does a transistor electronically switch the output on?

Asked by Wiki User

A transistor can electronically switch the output by controlling the flow of current between its two terminals, called the collector and emitter. It has a third

Read more

Electronics Engineering

PN junction diode made of silicon is the value of voltage depends exponentially on the current through the diode.?

Asked by Wiki User

No, the voltage across a silicon PN junction diode does not depend exponentially on the current through the diode. The relationship between voltage and current

Read more

Astronomy

+1

Is there such a thing as warp speed?

Asked by Wiki User

Not in our present understanding of physics. In all of our present mainstream physics’ rulesets, in order for any object with mass to travel at the speed of lig

Read more

Bachelors Degrees

+3

What is the pin diagram of ic 7812?

Asked by Wiki User

website Picture in context can be found here: http:/hamradio.lakki.iki.fi/new/Datasheets/tr

Read more

Science

+3

What are subjects in ECE and EEE?

Asked by Wiki User

sciences